Protech-audio MX407 Manuel d'utilisateur télécharger pdf

PROTECH

WWW.PROTECHAUDIO.COM

1/05

Protech Audio Corporation, PO Box 597, 192 Cedar River Road, Indian Lake, New York, 12842, Voice 518-648-6410 Fax 518-648-6395

All Quicktrack products use a consistent ground scheme. The MXT-1 power supply provides the

necessary ground conductor. Power supplies without the 3rd conductor ground should not be used

with Quicktrack products.

CAUTION: Do not plug power supply into AC receptacle until the secondary conductors have been

attached to the Quicktrack module. Doing so may cause the power supply conductors to short and

damage the supply.

Installion steps for the Quicktrack modules are as follows;

1- Remove the cover screw (All modules except MX410) and cover.

2- Press down on the lower edge of the Quicktrack mounting extrusion until the lower edge of the

printed circuit assembly comes free.

3- Slip the printed circuit assembly out of the upper edge of the mounting extrusion.

4- Mount the Quicktrack mounting extrusion in an appropriate location, away from moisture, heat

sources, and AC fields.

5- Connect all audio connections to the barrier connector using double conductor shielded cables

designed for low level audio signals. Do not use multiple solid conductor cables.

6- Connect the 3 power supply conductors to the power supply connection points on the barrier

connector.

7- Plug the power supply into an AC receptacled.

8- Check for proper illumination of the LED power indicator.

9- Adjust all audio levels as necessary.

10- Mount the cover onto the Quicktrack module being careful not to over-tighten the mounting

screw.

All initial adjustments on the MX407 are made at the factory. If after installing the unit higher or lower output

levels are desired, adjust inputs using trimpots as indicated.

The Model MX407 has two microphone inputs, and two line

inputs, mixed to a common line output. Each microphone

input has 15 volt phantom power circuitry, which is activated

by a push-on shunt (jumper). The line inputs have a 6dB pad,

which is also activated by a push-on shunt. All inputs have

adjustable gain.

All inputs, and the output, are electronically balanced. The

output may be used in either a balanced or unbalanced

configuration. Requires low voltage AC power (See MXT-1).

MODEL MX407

=6dB Pad

=Phantom Power

Shunt

INSTALLATION & OPERATION

MANUAL

MX407 AUDIO MIC/LINE MIXER, Rev. A

1 2

WWW.PROTECHAUDIO.COM 1

Résumé du contenu

Page 1 - WWW.PROTECHAUDIO.COM

PROTECH®WWW.PROTECHAUDIO.COM1/05Protech Audio Corporation, PO Box 597, 192 Cedar River Road, Indian Lake, New York, 12842, Voice 518-648-6410

Page 2

Protech Audio Corp. 192 Cedar River Road, Indian Lake, New York 12842 Voice 518-648-6410 Fax 518-648-6395PROTECH®INSTALLATION & OPERATION

Commentaires sur ces manuels

Pas de commentaire

Protech-audio MX407 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Audio Protech-audio MX407. Protech Audio MX407 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Protech-audio MX407